Champion Power Equipment PP-3 Manual de usuario descargar pdf (Pagina 32)

CONTROL PANELS

Step Soap Quantity

This setting allows soap quantity control for the step.

Setting name: STEP X SOAP QUANTITY

Allowed values: MIN, INT, MAX

Default value: MIN

System States

There are a few states of operation in the controller.

¾ Power Up State

¾ Off State

¾ Wash State

¾ Hold / Clean State

Power up State

This state is active on power-up, and also after a Dry Fire (when no water is present in wash

tank).

A lamp test is performed on the initial power up, all LED’s are lit up for 5 seconds.

Following this test, the software number and revision are displayed. These are useful for

troubleshooting purposes when several versions exist in the field. The first line shows the

software number (341) and the second line shows the revision number (1.51).

In this state, all outputs are turned off, and the 1

line of the display continually scrolls

FILL WASH TANK WITH HOT WATER, and the current water temperature (or

empty tank temperature) on the 2

line. All LED’s are off, except the currently selected

language, if selected.

The following counters are reset in this mode:

¾ Total wash time with current soap load (linked to Change Water state)

¾ Total soap injection time for both soap pumps

Once the tank has been filled with water, press the STOP key to enter the OFF state.

From the POWER UP state, the cycle programming and low-level programming menus are

accessible with the proper key sequence.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 66 67

Sin comentarios

Champion Power Equipment PP-3 Manual de usuario Pagina 32