Champion Power Equipment PP-3 Manual de usuario descargar pdf (Pagina 37)

CONTROL PANELS

Temperature Probe Error

All probes are typically type-K probes. All temperature readings normally associated with a

type-K probe are considered valid by the controller. However, if the probes become

disconnected or otherwise open, the controller will sound the buzzer and scroll

TEMPERATURE PROBE ERROR on line 1 of the display. The second line will display

the probe number(s) of the defective probe(s).

1 is water temperature probe

2 is heater sheath temperature probe

3 is sanitizing tank probe

Pressing any key shuts the buzzer off, but will not remove the error message. The only way

to remove the error message is to resolve the probe connection problem.

When these probe errors occur, all outputs are shut off.

External DC Error

The controllers DC I/O connector has a +5VDC supply. This supply is protected against

over-currents. Should this occur, the unit will disconnect the supply and report

EXTERNAL DC ERROR. The outputs are shut down and the only way to reset this is to

resolve the problem (most likely a short). Again, pressing any key will shut off the buzzer.

Omron Messages

The Omron Inverter may have errors or warnings of its own. Here’s a list of errors flagged.

In some cases, the Omron inverter will shut down (and let the motor coast to a stop).

Error detected Message scrolled

OVERCURRENT ERROR

OVERVOLTAGE ERROR

OL2

INVERTER OVERLOAD ERROR

INVERTER OVERHEAT ERROR

EFx/STP

EXTERNAL FAULT ERROR

INTERNAL FAULT ERROR

OL1

MOTOR OVERLOAD ERROR

OL3

OVERTORQUE ERROR

UV1

UNDERVOLTAGE ERROR

GROUND FAULT ERROR

COMMUNICATIONS ERROR

OFF

NO POWER ERROR

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 66 67

Sin comentarios

Champion Power Equipment PP-3 Manual de usuario Pagina 37